Anritsu S251C User Manual download pdf (Page 32)

Symbols

Table 2-1 provides a listing of the symbols used as condition indicators on the LCD display.

Self Test

At turn-on, the Site Master runs through a series of quick checks to ensure the system is

functioning properly. Note that the battery voltage and temperature are displayed in the

lower left corner below the self test message. If the battery is low, or if the ambient temper

ature is not within the specified operational range, Self Test will fail. If Self Test fails and

the battery is fully charged and the Site Master is within the specified operating temperature

range, call your Anritsu Service Center.

Chapter 2 Functions and Operations

2-15

Icon Symbol

Site Master is in Hold for power conservation. To resume sweeping, press

the

RUN/HOLD key. After 10 minutes without a key press, the Site Master

will automatically activate the power conservation mode.

Integrator Failure. Intermittent integrator failure may be caused by inter

ference from another antenna. Persistent integrator failure indicates a need

to return the Site Master to the nearest Anritsu service center for repair.

Lock fail indication. Check battery. (If the Site Master fails to lock with a

fully charged battery, call your Anritsu Service Center.)

When calibration is performed, the Site Master stores the ambient temper

ature. If the temperature drifts outside the specified range, this indicator

will flash. A recalibration at the current temperature is recommended.

Indicates the remaining charge on the battery. The inner white rectangle

grows longer as the battery charge depletes.

Indicates internal data processing.

The Site Master has been calibrated.

The Site Master has not been calibrated.

Table 2-1. LCD Icon Symbols

HOLD

CAL ON

CALL OFF

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 82 83

No comments

Anritsu S251C User Manual Page 32